NSK IHN010 Induction Bearing Heater Tools (Includes Backpack; Heats Bearings 20mm OD To 160mm OD And Width To 60mm And Weight To 10Kg)

Technical Data IHN010

Voltage (± 9%): 1 ~ 110 – 240V / 50 – 60Hz

Recommended circuit protection 10.5A circuit breaker (240V) 6.5A circuit breaker (110 – 115V)

Power consumption (maximum) 1.5kVA

Temperature control 20 – 180°C, in steps of 1°C 68 – 356°F, in steps of 2°F

Temperature probe K-type thermocouple with magnetic bracket

Power range 20 – 100%, in steps of 20% Time mode 0 – 10 minutes, in steps of 0.1 minutes

Operating modes Automatic temperature or time mode

Demagnetisation, automatic Residual magnetism < 2A/cm

Overall dimensions 340 x 250 x 64mm (over cone 121mm)

Weight 3.5kg Workpiece: Inner diameter Width External diameter 20mm and above Up to 60mm Up to 160mm

Workpiece maximum weight Up to 10kg

Workpiece materials Ferritic metals (magnetic)

Maximum heating temperature < 180°C / 356°F

Authorisations, inspections CE

The IHN010 induction heater is designed for heating rolling bearings and other ferritic, circular workpieces. The heat causes the workpiece to expand, which eliminates the need to use force during installation. A 90°C (194°F) temperature difference between the bearing and shaft is sufficient to enable easy installation. At an ambient temperature of 20°C (68°F), the bearing must therefore be heated to 110°C (230°F)