One of the essential types of pumps in industrial and home plumbing systems is a pressure booster water pump. It is a type of pump used to raise the pressure and flow of water, gas, or other liquids to reach the targeted point. In order to have the pump function properly, you need one more thing- having it installed properly in your facility. Here are the main steps to help you install a booster water pump correctly.

Step One: Locate the Position of Installation 

This is probably the most important step when installing a booster pump in your facility. The best location for booster pumps is immediately after the water shutoff valve, which is mainly in the basement. Some of the factors that you want to factor in when selecting the point of installation include: 

• The location should be easy to access. 
• Position it where you will need minimal piping, especially the use of elbows. 
• Make sure the location is safe.

Step Two: Get the Right Measurements and Cut the Pipe 

Once you have determined where to install the pump, get the right measurements to establish the exact point to cut the piping line. At this point, you need to think about the size of all plumbing components that will be used, such as pipe threads, the pump, and elbows. It will be a great idea to measure several times for confirmation to avoid making mistakes at this stage.  

Before cutting the pipes, switch off the water, gas, or liquid from the main valve. If you are dealing with a flammable liquid or gas, make sure all of the remnants are drained away for safety. 

Using a tube cutter, carefully rip the section that the booster pump will occupy. Then, remove the blurs and shavings that were created by the cutter so that the connections will be smooth and strong. 

Step Three: Install the Pump 

To install the booster water pump, start by installing the elbows into the main water or gas pipes, ensuring they are pointing towards the pump. Then, add the unions that are needed for the installation. Do not forget to include the check valve, a one-way valve that helps to avoid liquid from flowing black.

 It might also be a good idea to install a pressure relief valve, which helps release excess pressure from your system. They are very useful, especially in industrial facilities, because they help to prevent catastrophic failures when pressure surpasses the set limit.

Step Four: Turn the Water On Again 

Once properly installed, it is time to turn the water or gas on and let it flow to the pump. Make sure to do it slowly as you check for signs of leakage. If everything is okay, let the pump prime and turn it on to see how effectively it helps to boost the pressure. You have finally done it. Congratulations!

If your water, gas, or other liquid is not getting to the targeted level, consider acquiring the right booster pump from trusted dealers. Then, follow the steps we have listed in this post to install it correctly. Remember to inspect the pump carefully and have it repaired promptly in case issues are noted.