DIXON 4P3 1/4 HOLEDALL SOLID MALE COUPLING

Dixon Valve & Coupling Dixon&Reg; 4P3

UPC: | UNSPSC: 40141734 | GTIN:

Pipe, Tube & Hose Fittings > Tube & Hose Fittings > Hose End Fittings

Dixon® Male Coupling, Uni-Range, Series: Holedall™, Fitting/Connector Type: Coupling, 1/4 in ID x 42/64 to 46/64 in OD Nominal, MNPT, 2-9/16 in Length, Carbon Steel, Plated, 7/8 in H, Domestic

Features:

• Designed for smaller hose systems, these couplings may be used for hose ID's of 1/4 - 1 in
• Arrives complete with factory assembled stem and ferrule combination
• The coupling system requires no bolts and results in a clean coupling with no protrusions
• The holedall coupling provides long lasting efficiency and safety
• These fittings can be crimped or swaged
• Plated carbon steel stem and ferrule
• Other hose OD's available, contact Dixon
• Dixon holedall stems and ferrules are specifically designed to be used together as a coupling system
• Due to differences in dimensions and tolerances, for safety reasons, do not use other manufacturer's stems or ferrules with Dixon holedall products
• Do not use a wrench or vice on ferrule
• Holedall couplings, regardless of coupling style, are never to be used for steam service at any pressure
• Holedall fittings are not to be used with cable reinforced high pressure hose, 4 or 6 braid wire hydraulic hose or any other service not listed in the recommendations
• Externally swaged holedall couplings, to perform satisfactorily, must be applied properly in accordance with Dixon's assembly procedures, using correct die and ferrule for that particular hose end OD
• Dixon's die and ferrule Recommendation guide is to be used to select correct dies and ferrules
• Hose service working pressure (including surges and spikes) is never to exceed the maximum recommended working pressure for the fitting
• The assembly's (hose + coupling) maximum working pressure is the lesser of the hose rated working pressure or the coupling rated working pressure
• Media being transported through the hose should be compatible with the stem material
• Compatibility of ferrule material with the environment in which it will be used is recommended
• For applications other than the ones list, please consult Dixon
• Warning: this product contains a chemical known to the state of California to cause birth defects or other reproductive harm

Specs:

• Fitting/Connector Type: Coupling
• Nominal Size: 1/4 in ID x 42/64 to 46/64 in OD
• Domestic/Import: Domestic
• End Style: MNPT
• Dimensions: 7/8 in H
• Material: Carbon Steel
• Finish: Plated
• Type: Uni-Range
• Length: 2-9/16 in
• Series: Holedall™

Packaging:

• Weight: 0.19 lb