Image for Illustration purposes only. Actual product may vary
Curtis CJ654-9K Size: 3" boot kits
MODEL CJ654-9K
Contact supplier for technical support on: 800-466-2144
$91.26 Each
Prices are subject to change
FREE SHIPPING ON ORDERS OVER $1
Select Quantity
Orders over $500 qualify for a Free Gift
Typically Ships in: 3 days
Returnable: See conditions
LUBRICATION INFORMATION
What You Should Know About Lubrication If You Intend to Machine Your Part
Curtis furnishes universal joints with hubs in a machineable state. Our patented disassembly feature allows for special machining in the field, when required. Our joints are shipped unlubricated, which allows you to disassemble and machine your joint without degreasing the parts. This also enables you to utilize your preferred brand of lubrication.
For lubricating the bearing area of the joint, Curtis employs a ball spring oil fitting in its 1″ through 4″ diameter universal joints. Special flush type and hydraulic grease fittings are available upon request. Contact Curtis for assistance in determining the proper fitting for your application.
The load bearing surfaces of a universal joint should be well-lubricated at all times to prevent premature failure.
We recommend that the universal joints be lubricated with a molybdenum disulfide (MoS2)-based, free-flowing lubricant prior to use and every40–50operating hours thereafter.
No Grooves on Hub of Joint Needed to Retain Boot!
For both intermittent and continuously rated joints where lubrication such as an oil bath is not available, we recommend the use of boots suitable for grease packing to retain lubricant and keep our contaminants. These are available in kits for all sizes of single joints and can be used in pairs on the double joint. Curtis boots do not require grooves on the hub of the joint to hold the boot in place.
Curtis Boot Kits consist of one boot and two ties. Part numbers may be obtained on the Selection Guide provided above.
Curtis Boots are typically manufactured from a polyvinyl chloride rubber blend, which is impervious to ozone and is ultraviolet stabilized. Our boots have a useful temperature range of -60∞F to +220∞F.
Custom Design Boots Available
Curtis will manufacture boots per your drawing requirements to meet your operating criteria or will design and fabricate boots to meet your specific needs. Send your requirements to Curtis, or Contact Curtis’ engineering department direct at 888-287-8477 for assistance in specifying a boot for your application.
Special Materials Available
Curtis can provide boots manufactured from various materials. Contact Curtis’ engineering department at 888-287-8477 for a list of available materials or advise them of your operating environment and they will specify a material for your application.
"A" | "B" | "C" | |
---|---|---|---|
Catalog Number | Universal Joint Diameter | Maximum Outside Diameter | Overall Length |
CJ654-9K | 3.000 | 6.000 | 5.625 |
When you get to checkout, you’ll be able to select a free gift! Depending on the cart value, you’ll be shown relevant gifts your order qualifies for.
$500
MRO Hat
MRO Golf Balls
MRO Hi-Vis Vests
MRO Mug
$750
32oz Water Bottle
Throw Blanket
30 piece Hex Set
Telescopic Pick Up
$1,250
Golf Cooler
11-in-1 Screw Driver Set
Gorilla Grip Knee Pad
John Deere Oilskin Hat
$2,500
Igloo 1/2 Gallon Jug
Rechargable Headlamp
Larix Trucker Hat
$5,000
Igloo 10 Gallon Cooler
Igloo Party Bucket Cooler
Klein Tools Speaker
Klein Tools 8-in-1
$7,500
GX-6F Pro Golf Range Finder
Bushnell Outdoorsman Speaker
Jaeger 24px Ratcheting Wrench Set
Aspen Beverage Bucket